MultiMa
The MultiMa is our most advanced control system. It was specially developed to control the climate, irrigation and energy consumption in a greenhouse environment. Our frequent program updates and new programs ensure the system continues to meet the latest requirements, such as underground heat and cold storage. The MultiMa can be customized to fit your specific needs and is easily expandable as your company grows (up to 20 blocks, 500 valves and 50 valve groups). The MultiMa can be configured from the following control modules:
- Blocks
- Ventilation
- Central Heating
- Hot Air Heaters
- Weather
- Apex Screen
- Transport
- Boiler
- Buffer
- Heat Exchanger
- CHP
- CO2
|
- Cyclic Lighting
- Supplementary Lighting
- Roof Sprinkling
- Fogging
- Fans
- Exchange Valve
- Autonomous
- Raised Heating
- Pad & Fan
- Water
- Energy Control
|
| |
|
The irrigation module adds further options and benefits:
Benefits:
- A reliable, high-quality design
- Optimum irrigation and fertigation control
- Suitable for all types of recirculation
- Suitable for substrate, ebb and flow and sprinkler irrigation
- A wide range of setting options
- Fertilizers can be drawn from up to 8 fertilizer tanks at once
The MultiMa comes with a PC and the Synopta® operating software. |
Options:
- Up to 500 valves
- Up to 50 valve groups
- Irrigation using a number of valves at once (12 valves)
- Irrigation starts based on:
Radiation sum
Contact start
Maximum pause
Start time
Manual start
Transpiration start
Slab moisture
Drain
Tensio start
ProDrain controller
- Radiation influence on the EC control
- Control the quantity of drain water and reuse it based on the supply ProDrain controller-EC
- Various other options
|
MultiMa version 4.9
MultiMa version 4.9 includes the following special new features compared to version 4.8:
- The layout of the settings has been simplified. A number of recipes can now be set for each irrigation unit, which means that you can program a recipe for every period and phase of each valve group.
- A flow rate measurement is supported for each valve.
- EC and pH control has been improved in a number of key areas.
- A number of contacts can now be linked to an irrigation group, which activate irrigation if a measured value drops below a pre-set minimum or exceeds a pre-set maximum. The following signal types have also been added: percentages, grams and digital.
- The ability to assign priorities to irrigation groups allow you to adjust the order in which they are activated.
- After dividing fertilizer dosing into cycles, a delay time can be set between the cycles.
- The pulse dosing of additional solution can be delayed until shortly before the valve closes.
- A number of readouts have been added, such as ‘irrigation pause time elapsed’ and ‘radiation sum accumulated since last irrigation cycle’.
- A number of alarms have been added, including an alarm if the amount of water drawn is too low and a unit leakage alarm.
- New features designed especially for spray booms:
The ability to disable the alarm notifications which are shown when a valve fails to open or is skipped.
A spray boom can now be re-activated while irrigation is in progress.
- New features designed especially for Ebb-and-Flood control:
A readout indicating the remaining flooding time of the ebb-and-flood surface has been added.
The flooding time can now be raised or lowered for each valve.
Download the leaflet
The leaflets available on this site are in PDF format. You can view these folders using Acrobat Reader, which is free to download from the Adobe website. Click on the icon below to go to their website.
NEWS
